Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. Remove the radiator cap.



    A070279E01
  1. Remove the service hole cover from the engine under cover No. 1.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.



    A070477E01
  1. Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.



2. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY
  1. Remove the 2 nuts and throttle body cover sub-assembly.



3. REMOVE AIR CLEANER HOSE ASSEMBLY
  1. Disconnect the vacuum hoses (for the P/S idle-up and fuel pressure regulator) and ventilation hose.

  1. Remove the air cleaner hose assembly.



4. REMOVE THROTTLE W/MOTOR BODY ASSEMBLY


    A133759
  1. Disconnect the water by-pass hose, water by-pass hose No. 7 and the throttle position sensor connector.



    A133760
  1. Remove the 3 bolts and nut.

  1. Remove the throttle body and the throttle body gasket.