Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2


    B062749E01
  1. Remove the screw <E>.

  1. Disengage the 3 clips and remove the No. 2 instrument panel under cover sub-assembly.



2. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY


    B062750E01
  1. Remove the screw <F> and glove compartment door.

  1. Deform the upper part of the glove compartment door to release the stoppers.

  1. Pull the glove compartment door upward to remove it.



3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO.2


    B062751E01
  1. Remove the 4 screws <E>.

  1. Disengage the 2 claws and remove the instrument panel finish panel.



4. REMOVE ECM


    A072553
  1. Disconnect the 5 ECM connector.

  1. Remove the 3 nuts and ECM.

  1. Remove the 2 screws and ECM bracket No. 1 from the ECM.

  1. Remove the 2 screws and ECM bracket No. 2 from the ECM.