Home › STEERING › POWER STEERING › POWER STEERING LINK

POWER STEERING LINK > INSPECTION

for Preparation Click here



1. INSPECT POWER STEERING RACK


    F043549
  1. Insert a wire into the vent hole of the steering rack by 30 mm (1.18 in.), and ensure that the vent hole is not clogged with grease.

    HINT:
    If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.



2. INSPECT TIE ROD END SUB-ASSEMBLY LH


    ZK08184
  1. Flip the ball joint stud back and forth 5 times as shown in the figure, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per 1 turn and take the torque reading on the 5th turn.

    Torque:
    Turning:
    0.29 to 1.96 N*m{ 2.9 to 20.0 kgf*cm , 2.57 to 17.35 in.*lbf }



3. INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Inspect the RH side by the same procedures with LH side.