POWER STEERING LINK > DISASSEMBLY |
| 1. FIX POWER STEERING LINK ASSEMBLY |
![]() |
Using SST, remove the 2 turn pressure tubes.
![]() |
Using the SST, fix the gear assembly between aluminum plates in a vise as shown in the illustration.
| 2. REMOVE TIE ROD END SUB-ASSEMBLY LH |
![]() |
Place matchmarks on the tie rod end, lock nut and rack end.
Loosen the lock nut, remove the tie rod end and lock nut.
| 3. REMOVE TIE ROD END SUB-ASSEMBLY RH |
| 4. REMOVE STEERING RACK BOOT CLAMP LH |
![]() |
Using pliers and a screwdriver, loosen the clamp.
| 5. REMOVE STEERING RACK BOOT CLAMP RH |
| 6. REMOVE STEERING RACK BOOT CLIP LH |
Using pliers, remove the clip.
| 7. REMOVE STEERING RACK BOOT CLIP RH |
| 8. REMOVE STEERING RACK BOOT LH |
| 9. REMOVE STEERING RACK BOOT RH |
| 10. REMOVE STEERING RACK END SUB-ASSEMBLY |
![]() |
Using a screwdriver and a hammer, stake back the washer.
![]() |
Using a spanner to hold the steering rack steady, and using SST, remove the rack end.
Remove the craw washer.
Employ the same manner described above to the other side.
| 11. REMOVE RACK GUIDE |
![]() |
Using SST, remove the lock nut.
![]() |
Using a hexagon wrench (24 mm), remove the rack guide spring cap.
Remove the spring and rack guide.
| 12. REMOVE POWER STEERING CONTROL VALVE |
![]() |
Remove the 2 bolts.
Pull out the control valve assembly with the control valve housing.
Remove the O-ring.
Carefully mount the control valve assembly in a soft jaw vise.
![]() |
Using SST, remove the bearing guide nut.
Remove the O-ring.
Remove the dust cover.
![]() |
Using SST and a hammer, drive out the oil seal from the bearing guide nut.
Wind vinyl tape to the control valve shaft.
![]() |
Using a plastic hammer, tap out the valve assembly with the bearing guide nut from the control valve housing.
Using a screwdriver, remove the 4 teflon rings from the control valve assembly.
![]() |
Using a screw extractor, remove the union seat from the control valve housing.
| 13. REMOVE POWER STEERING CONTROL VALVE UPPER OIL SEAL |
![]() |
Using SST, press out the bearing and oil seal from the control valve housing.
| 14. REMOVE CYLINDER END STOPPER |
![]() |
Using SST, remove the stopper.
Remove the O-ring from the stopper.
| 15. REMOVE STEERING RACK AND OIL SEAL |
![]() |
Using SST, press out the steering rack and oil seal.
Remove the oil seal from the steering rack.
| 16. REMOVE STEERING RACK PISTON RING |
Using a screwdriver, remove the teflon ring and O-ring from the steering rack.