VANE PUMP > REMOVAL |
| 1. DRAIN POWER STEERING FLUID |
Check the fluid level.
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.*1
Repeat (*1) several times.
Stop the engine.
![]() |
Check for foaming or emulsification.
Especially, if the system has to be held twice because of foaming or emulsification, check for fluid leaks in the system.
Check the fluid level.
| 2. REMOVE AIR CLEANER ASSEMBLY |
| 3. REMOVE VANE PUMP V BELT |
![]() |
Loosen the belt tension by turning the belt tensioner counterclockwise, and remove the belt.
| 4. SEPARATE OIL RESERVOIR TO PUMP HOSE NO. 1 |
![]() |
Loosen the 2 clips and disconnect the 2 vacuum hoses.
![]() |
Loosen the clip and disconnect the hose.
| 5. SEPARATE PRESSURE FEED TUBE ASSEMBLY |
![]() |
Remove the union bolt and a gasket, disconnect the pressure feed tube.
| 6. REMOVE VANE PUMP ASSEMBLY |
![]() |
Remove the 2 bolts and nut.
Using a "torx" socket (E10), remove the stud bolt.