Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > DISASSEMBLY

for Preparation Click here



1. MEASURE VANE PUMP ROTATING TORQUE


    F004807
  1. Check that the pump rotates smoothly without abnormal noise.

  1. Using a torque wrench, check the pump rotating torque.

    Torque:
    Rotating torque:
    0.28 N*m{ 2.8 kgf*cm , 2.4 in.*lbf } or less



2. REMOVE VANE PUMP PULLEY


    F004808
  1. Using SST to stop the pulley rotating, loosen the nut.

    SST
    09960-10010   (09962-01000, 09963-01000)

  1. Remove the nut and vane pump pulley from the vane pump shaft.



3. REMOVE POWER STEERING SUCTION PORT UNION
  1. Remove the bolt and suction port union.

  1. Remove the O-ring from the suction port union.



4. REMOVE PRESSURE PORT UNION
  1. Remove the pressure port union, flow control valve and spring.

  1. Remove the O-ring from the pressure port union.



5. REMOVE VANE PUMP REAR HOUSING
  1. Remove the 4 bolts and vane pump rear housing.

    HINT:
    If the wave washer and side plate are stuck to the vane pump rear housing, lightly tap the vane pump rear housing with a plastic hammer, and remove the wave washer and side plate.

  1. Remove the 2 O-rings from the rear housing.



6. REMOVE SIDE PLATE AND WAVE WASHER


7. REMOVE VANE PUMP CAM RING
  1. Using a screwdriver, remove the snap ring from the vane pump shaft.

  1. Remove the cam ring.



8. REMOVE VANE PUMP ROTOR
  1. Remove the vane pump rotor with the 10 vane plates.

    NOTICE:
    Be careful not to drop the plate.



9. REMOVE VANE PUMP SHAFT


10. REMOVE STRAIGHT PIN
  1. Remove the 2 pins from the vane pump front housing.



11. REMOVE VANE PUMP HOUSING OIL SEAL

NOTICE:
When using a vise, do not overtighten it.



    F001511E01
  1. Using a screwdriver with vinyl tape wound around its tip, remove the housing oil seal.

    NOTICE:
    Be careful not to damage the vane pump front housing.