Home › STEERING › POWER STEERING › VANE PUMP

VANE PUMP > REASSEMBLY

for Preparation Click here


NOTICE:
When installing, coat the parts indicated by the arrows with power steering fluid (Click here).



1. INSTALL VANE PUMP HOUSING OIL SEAL


    W004761E01
  1. Coat a new oil seal lip with power steering fluid.

  1. Using SST, press in the oil seal.

    SST
    09950-60010   (09951-00320)
    09950-70010   (09951-07100)

    NOTICE:
    Make sure to install the oil seal facing in the correct direction.



2. INSTALL VANE PUMP SHAFT


3. INSTALL STRAIGHT PIN
  1. Using a plastic hammer, tap the 2 new pins to the vane pump front housing.

    NOTICE:
    Be careful not to damage the pins.



4. INSTALL VANE PUMP CAM RING


    F004809E01
  1. Install the cam ring with the inscribed mark facing outward.

    HINT:
    Align the holes of the cam ring with the straight pins.



5. INSTALL VANE PUMP ROTOR
  1. Install the vane pump rotor with the inscribed mark facing outward.

  1. Install a new snap ring to the vane pump shaft.



    F004810E01
  1. Install the 10 plates with the round end facing outward.

  1. Install a new gasket on the front housing.

    NOTICE:
    Be careful of the direction of the gasket.



6. INSTALL VANE PUMP SIDE PLATE REAR
  1. Align the holes of the plate and 2 straight pins.



7. INSTALL VANE PUMP REAR HOUSING


    F001507
  1. Install the wave washer so that its protrusions fit into the slots in the side plate.

  1. Coat 2 new O-rings with power steering fluid and install them to the rear housing.

  1. Install the rear housing with the 4 bolts.

    Torque:
    24 N*m{ 240 kgf*cm , 17 ft.*lbf }



8. INSTALL PRESSURE PORT UNION
  1. Install the spring to the vane pump front housing.

  1. Install the flow control valve facing the correct direction .

  1. Coat a new O-ring with power steering fluid and install it to the pressure port union.

  1. Install the pressure port union.

    Torque:
    83 N*m{ 850 kgf*cm , 61 ft.*lbf }



9. INSTALL POWER STEERING SUCTION PORT UNION
  1. Coat a new O-ring with power steering fluid and install it to the suction port union.

  1. Install the suction port union with the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



10. INSTALL VANE PUMP PULLEY


    F004808E01
  1. Install the vane pump pulley and nut to the vane pump shaft.

  1. Using SST to stop the pulley rotating, torque a new pulley set nut.

    SST
    09960-10010   (09962-01000, 09963-01000)

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



11. MEASURE VANE PUMP ROTATING TORQUE


    F004807
  1. Check that the pump rotates smoothly without abnormal noise.

  1. Using a torque wrench, check the pump rotating torque.

    Torque:
    Rotating torque:
    0.28 N*m{ 2.8 kgf*cm , 2.4 in.*lbf } or less