VVT SENSOR > INSTALLATION |
| 1. INSTALL VVT SENSOR |
![]() |
LH bank side VVT sensor.
Apply a light coat of engine oil to an O-ring of the VVT sensor.
Install the VVT sensor with the bolt.
Connect the VVT sensor connector.
![]() |
Connect the water by-pass hoses No. 4 and No. 5.
![]() |
RH bank side VVT sensor.
Apply a light coat of engine oil to an O-ring of the VVT sensor.
Install the VVT sensor with the bolt.
Connect the VVT sensor connector.
| 2. INSTALL AIR CLEANER ASSEMBLY |
![]() |
Install the air cleaner with the 2 bolts.
Tighten the 2 hose clamps.
![]() |
Install the 2 wire harness clamps.
Connect the mass air flow meter connector.
Connect the vacuum hose.
![]() |
Connect the ventilation hose No. 2.
| 3. CONNECT VENTILATION HOSE NO.2 |
| 4. ADD ENGINE COOLANT |
Slowly fill the system with engine coolant.
Install the radiator cap securely.
Bleed the cooling system.
Open the heater water valve while warming up the engine.
Maintain the engine speed at 2,000 to 2,500 rpm and warm up the engine.
Stop the engine and wait until the coolant cools down.
Add coolant into the reservoir until the coolant level is FULL.
| 5. CHECK FOR ENGINE COOLANT LEAKS |
Fill the radiator with coolant and attach a radiator cap tester.
Pump it to 118 kPa (1.2 kgf/cm2 17.1 psi), then check for leakage.
| 6. INSTALL V-BANK COVER |
Install the V-bank cover with the 2 nuts.