Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT VVT SENSOR
  1. Turn the ignition switch to the ON position.

  1. Check that the voltage between terminal VC1 and ground is 5 V.

    HINT:
    For the terminal arrangement of the engine ECU (Click here).

  1. While turning the crankshaft pulley by hand, measure the voltage between each terminal.
    Check that the voltage changes between the Hi range and Lo range shown in the table below.

    HINT:
    For the terminal arrangement of the ECM (Click here).


    Sensor position
    Terminal No.
    Voltage (Hi)
    Voltage (Lo)
    Bank 1
    VV1+ ←→ VV1-
    3.375 to 4.950
    0.450 to 1.375
    Bank 2
    VV2+ ←→ VV2-
    3.375 to 4.950
    0.450 to 1.375