Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY


    A076407
  1. Disconnect the wire harness.

    1. Remove the bolt and wire harness stay.

    2. Disconnect the connector from the generator assembly.

    3. Remove the terminal cap and nut.

    4. Disconnect the wire harness from the terminal B.



    A076408
  1. Remove the 2 bolts and wire harness clamp bracket from the generator assembly.



    A076409
  1. Remove the 2 bolts and generator assembly.



2. REMOVE ENGINE UNDER COVER ASSEMBLY REAR
  1. Remove the 4 bolts and the engine under cover assembly rear.



3. SEPARATE COOLER COMPRESSOR ASSEMBLY


    A076416
  1. Remove the bolt and separate the suction hose sub-assembly.

  1. Disconnect the cooler compressor assembly connector.

  1. Remove the 4 bolts and separate cooler compressor assembly from the V-ribbed belt tensioner assembly.



4. REMOVE CRANKSHAFT POSITION SENSOR


    A076417
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt and the crankshaft position sensor.