Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY


    A075905
  1. Check for operating sound [A].

    1. Turn the ignition switch ON.

    2. When turning the accelerator pedal position sensor lever, listen to a running sound of the motor. Also, check that there is no friction sound.
      If operation is not as specified, check the throttle control motor , wiring and ECM.

  1. Inspect the throttle position sensor [B].

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON.

    3. When turning the accelerator pedal position sensor lever to the full-open position, check that the percentage of throttle valve opening angle (THROTTLE POS) of the CURRENT DATA.

      Standard percentage of the valve opening angle:
      60% or more

      If operation is not as specified, check that the accelerator pedal position sensor , the wiring and the ECM.
      If you do not have the intelligent tester, measure voltage between the terminals (VTA1 - E2, VTA2 - E2) of the ECM connector (Click here).

  1. Inspect the air assist system [C].

    1. Start the engine and check that the MIL does not illuminate.

    2. Let the engine warm up to the normal operating temperature.

    3. Switch the A/C compressor from ON to OFF, and check the idle speed.

      Idle speed (Transmission in neutral):
      700 +- 50 rpm

      NOTICE:
      Perform inspection under condition without electrical load.

  1. After checking the above [B] and [C], perform the driving test.