Home › BODY › SEAT › REAR NO. 1 SEAT ASSEMBLY

REAR NO. 1 SEAT ASSEMBLY > REASSEMBLY

for Preparation Click here



1. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER LH


    B050126E17
  1. Install the seat cushion cover to the seat cushion pad with new hog rings.

  1. Install the seat cushion cover with the pad to the seat cushion frame with new hog rings.

    HINT:
    When installing hog rings, take care to prevent wrinkles as much as possible.



2. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL REAR SEAT CUSHION UNDER COVER LH
  1. Install the under cover with the 5 clips.



4. INSTALL REAR SEAT CUSHION UNDER COVER RH
  1. Install the under cover with the 7 clips.



5. INSTALL SEPARATE TYPE REAR SEATBACK COVER LH


    B050126E17
  1. Install the seatback cover to the seatback pad RH with new hog rings.

  1. Install the seatback cover with the pad to the seatback frame with new hog rings.

    HINT:
    When installing hog rings, take care to prevent wrinkles as much as possible.



6. INSTALL SEPARATE TYPE REAR SEATBACK COVER RH

HINT:
Use the same procedures described for the LH side.



7. INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
  1. Install the 2 hinge with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



8. INSTALL REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



9. INSTALL REAR SEAT BELT OUTER CENTER
  1. Install the belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



10. INSTALL REAR SEAT ARMREST ASSEMBLY CENTER
  1. Install the armrest with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the armrest cover with the screw.



11. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY
  1. Install the 2 strikers with the 6 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



12. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY CENTER
  1. Install the hinge with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



13. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
  1. Install the hinge with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



14. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.