REAR NO. 2 SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) > DISASSEMBLY |
| 1. REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER RH |
![]() |
Disengage the claws and remove the 2 screws and reclining cover LH.
Using a screwdriver and remove the screw cover, screw and release handle RH.
![]() |
Disengage the claws and remove the 2 screws and reclining cover RH.
![]() |
Disengage the seatback cover hem.
Remove the tether anchor cover.
Open the fastener of the seatback cover and remove the rear seat protector.
![]() |
Push the claws and remove the 2 headrest supports.
Remove the seatback cover together with the pad.
Cut the hog rings and remove the seatback cover.
| 2. REMOVE REAR SEATBACK COVER RH |
![]() |
Insert a screwdriver between the seat cushion cover and seat cushion under cover.
Pry the seat cushion cover hem to disengage it.
Cut the hog rings and remove the seat cushion cover together with the pad.
Cut the hog rings and remove the seat cushion cover.
| 3. REMOVE REAR SEAT HINGE SUB-ASSEMBLY LH |
Remove the hinge cover, E-ring, pin, hinge guide and hinge.
| 4. REMOVE REAR SEAT HINGE SUB-ASSEMBLY RH |
![]() |
Using a screwdriver, remove the spring of the seat stay ball-joint.
Disconnect the ball-joint from the seat cushion frame.
Remove the hinge cover, E-ring, pin, hinge guide, spring and hinge together with the seat stay.
| 5. REMOVE REAR SEAT CUSHION UNDER COVER RH |
Remove the 4 screws and cover.
| 6. REMOVE REAR SEAT INNER BELT ASSEMBLY |
Remove the nut and belt.
| 7. REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY |
| 8. REMOVE FOLD SEAT LOCK CONTROL CABLE SUB-ASSEMBLY |