FUEL SYSTEM > PRECAUTION |
| 1.PRECAUTION |
Before starting on the work for the fuel system inspection and repair, disconnect the negative (-) terminal cable from the battery.
Do not smoke or work near fire when handling the fuel system.
Keep gasoline away from rubber or leather parts.
| 2.WORK FOR PREVENT GASOLINE FROM SPILLING OUT |
![]() |
Remove the circuit opening relay from the engine room relay block.
Start the engine. After the engine stopped, turn the ignition switch OFF.
Check that the engine does not start.
Remove the fuel tank cap, and let the air out of the fuel tank.
Disconnect the negative (-) terminal cable from the battery.
Reinstall the circuit opening relay.
| 3.FUEL SYSTEM |
![]() |
When disconnecting the high fuel pressure line, a large amount of gasoline will spill out, so observe these procedures.
Disconnect the fuel pump tube .
Drain the fuel remained inside the fuel pump tube.
In order to prevent the disconnected fuel pump tube from damaging and foreign objects from being mixed into, cover them with a vinyl bag.
Put a container under the connection.
![]() |
Observe these precautions when removing and installing the injectors.
Never reuse the O-ring.
When placing a new O-ring on the injector, do not damage it.
Coat the new O-rings with spindle oil or gasoline before installing. Do not use engine oil, gear oil or brake oil.
![]() |
Install the injector to the delivery pipe and lower intake manifold as shown in the illustration.
![]() |
Observe these precautions when disconnecting the fuel tube connector (Quick type A):
Remove the fuel pipe clamp No. 1.
Check that there is no dirt like mud on the pipe and around the connector before disconnecting them. Clean them if necessary.
Disconnect them by hand.
![]() |
When the connector and the pipe are stuck, pinch the fuel pipe with fingers and push the fuel tube connector to the fuel pipe by pressing the release buttons, then pull the connector out from the pipe.
Inspect that there is no dirt or the like on the seal surface of the disconnected pipe. Clean it away if necessary.
In order to prevent the disconnected pipe and connector from damaging and foreign objects from being mixed into, cover them with a vinyl bag.
![]() |
Observe these precautions when connecting the fuel tube connector (Quick Type A):
Check that there is no damage or foreign objects in the connected part of the pipe.
Match the axis of the connector with the axis of the pipe, and push into the connector until the connector makes a "click" sound. In case that the connection is tight, apply a little amount of fresh engine oil on the tip of the pipe.
![]() |
After having finished the connection, check if the pipe and the connector are securely connected by pulling them.
Check for any fuel leak.
Observe these precautions when disconnecting the fuel tube connector (Quick type B):
Check if there is any dirt like mud on the pipe and around the connector before disconnecting them. Clean the dirt away if necessary.
Disconnect them by your hands.
![]() |
When the connector and the pipe are stuck, push and pull the connector to free to disconnect and pull it out. Do not use any tool at this time.
Inspect if there is any dirt or the like on the seal surface of the disconnected pipe. Clean it away if necessary.
Prevent the disconnected pipe and connector from damaging and foreign objects from being mixed into by covering them with a vinyl bag.
![]() |
Observe these precautions when connecting the fuel tube connector (Quick type B):
Match the axis of the connector with the axis of the pipe, and push in the connector until the connector makes a "click" sound. In case that the connection is tight, apply a little amount of new engine oil on the tip of the pipe.
![]() |
After having finished the connection, check if the pipe and the connector are securely connected by pulling them.
Check for fuel leakage.
Observe these precautions when handling nylon tube.
| 4.CHECK FOR FUEL LEAK |
Check that there are no fuel leaks after doing maintenance to the fuel system .