Home › ENGINE ยท 1GR-FE › FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SUCTION WITH PUMP & GAGE TUBE ASSEMBLY


    A067098
  1. Install a new gasket onto the fuel tank.

  1. Set the fuel suction tube assembly to the fuel tank.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gage.

  1. Fit a spline of the fuel suction tube assembly into a keyway of the fuel tank.



    A076638E01
  1. Install a retainer.

    1. Using a new retainer, align mark on the retainer with a screw-threads starting point of the fuel tank.

    2. While holding the fuel suction tube assembly, tighten the retainer one complete turn by hand.



    A139371E01
  1. Using a SST, tighten the retainer one more complete turn, and position the mark on the retainer into a range A of the fuel tank.

    SST
    09808-14020   (09808-01410, 09808-01420, 09808-01430)

    HINT:
    1. Turn the retainer two complete turns and position the mark within the range A for the installation of the retainer.
    2. A rib on the retainer can be fitted into a tip of the SST.