Home › ENGINE ยท 1GR-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE VAPOR PRESSURE SENSOR


    A067106
  1. Remove the tube joint clip, and pull out the vapor pressure sensor.



2. REMOVE FUEL SENDER GAGE ASSEMBLY


    A067105
  1. Disconnect the fuel sender gage connector.

  1. Unlock the fuel sender gage, and slide it to remove.



3. REMOVE FUEL PUMP ASSEMBLY WITH FILTER


    A076666
  1. Using a screwdriver, disconnect the 4 snap-claws from the claw holes, and remove the sub tank.

    NOTICE:
    Do not damage the sub tank.



    A076667
  1. Disconnect the fuel pump connector.



    A076668
  1. Using a small screwdriver, disconnect the 4 claws from the claw holes, and remove the fuel pump with filter.

  1. Remove the fuel pump O-ring from the fuel pump.

  1. Remove the fuel pump spacer from the fuel pump.



4. REMOVE FUEL PUMP FILTER


    A076669
  1. Using a small screwdriver, pry out the clip.

  1. Pull out the fuel pump filter from the fuel pump.