POWER WINDOW CONTROL SYSTEM > Manual Up / Down Function does not Operate on Passenger Side Only |

| 1.CHECK WIRE HARNESS (POWER SOURCE) |
![]() |
Disconnect the P9 switch connector.
Turn the ignition switch ON.
Check the voltage between terminal 4 of the wire harness side connector of the switch and the body ground.
|
| ||||
| OK | |
| 2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (PASSENGER SIDE) |
![]() |
Remove the power window switch.
Check the continuity between the terminals of the switch connector when the switch is operated.
| Terminal No. | Switch | Specified Condition |
| 1 - 2, 3 - 4 | UP | Continuity |
| 1 - 2, 3 - 5 | OFF | |
| 1 - 4, 3 - 5 | DOWN |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SWITCH - MOTOR) (SWITCH - BODY GROUND) |
![]() |
Disconnect the P13 motor connector.
Check the continuity between the wire harness side connectors.
| Terminal No. | Specified Condition |
| P9-1 - P13-1 | Continuity |
| P9-3 - P13-2 |
Check the continuity between the P9 switch connector and the body ground.
| Terminal No. | Specified Condition |
| P9-1 - Body ground | No continuity |
| P9-3 - Body ground |
|
| ||||
| OK | |
| 4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
![]() |
Remove the motor.
Apply battery voltage to connector terminals 1 and 2.
Check that the motor rotates smoothly.
| Terminal No. | Specified Condition |
| Battery positive (+) → 1 Battery negative (-) → 2 | Motor gear rotates clockwise |
| Battery positive (+) → 2 Battery negative (-) → 1 | Motor gear rotates counterclockwise |
|
| ||||
| OK | ||
| ||