FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND FUEL LEAK |
When using the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and intelligent tester main switch ON.
Select the ACTIVE TEST mode on the intelligent tester.
Please refer to the intelligent tester operator's manual for further details.
![]() |
When not using the intelligent tester
Remove the circuit opening relay.
Using a service wire, connect terminals FP and +B of the relay block.
Turn the ignition switch ON, and check that the fuel pump operates.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.
![]() |
Check that the pulsation damper screw rises up when the fuel pump operates.
If operation is not as specified, check the following parts:
Turn the ignition switch OFF.
Disconnect the intelligent tester from the DLC3.
| 2. CHECK FUEL PRESSURE |
Check the battery positive voltage is above 12 V.
Disconnect the negative (-) terminal cable from the battery.
Remove the front fuel pipe from the LH delivery pipe .
![]() |
Install the front fuel pipe and SST (pressure gauge) to the delivery pipe with the 3 gaskets and another SST (adaptor).
Wipe off any splattered gasoline.
Reconnect the negative (-) terminal cable to the battery.
Connect the intelligent tester to the DLC3 (See step 1 in check fuel pump operation).
Measure the fuel pressure.
Disconnect the intelligent tester from the DLC3.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
After checking the fuel pressure, disconnect the negative (-) terminal cable from the battery and carefully remove the SST to prevent gasoline from splashing.
Reinstall the front fuel pipe to the LH delivery pipe .
Reconnect the negative (-) terminal cable to the battery.
Check for fuel leaks (See step 1 in check fuel pump operation).