Home › ENGINE ยท 2UZ-FE › FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SUCTION WITH PUMP & GAGE TUBE ASSEMBLY


    A133779
  1. Install a new gasket onto the fuel tank.

  1. Set the fuel suction with pump & gage tube assembly to the fuel tank.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gage.

  1. Fit the spline of the fuel suction with pump & gage tube assembly into the keyway of the fuel tank.



    A133780E01
  1. Install the retainer.

    1. Using a new retainer, align the mark on the retainer with the screw-thread starting point of the fuel tank.

    2. While holding the fuel suction with pump & gage tube assembly, tighten the retainer one complete turn by hand.



    A137683E01
  1. Using SST, tighten the retainer one more complete turn, and position the mark on the retainer into range A of the fuel tank.

    SST
    09808-14020   (09808-01410, 09808-01430)

    HINT:
    1. Turn the retainer two complete turns and position the mark within range A to install the retainer.
    2. A rib on the retainer can be fitted into the tip of SST.