Home › DRIVE LINE ยท PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > INSPECTION

for Preparation Click here



1. INSPECT PROPELLER SHAFT ASSEMBLY


    C061260
  1. Using a dial indicator, check the propeller shaft runout.

    Maximum runout:
    0.3 mm (0.012 in.)

    If the shaft runout is greater than maximum, replace the shaft.



2. INSPECT REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
  1. Check the spider bearings for wear or damage.

  1. Check the spider bearing axial play by turning the yoke with holding the shaft tightly.

    Maximum bearing axial play:
    0 mm (0 in.)

    If necessary, replace the spider bearing.