Home › DRIVE LINE ยท PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING


    F015023E06
  1. Place matchmarks on the flange yoke and sleeve yoke.



    C061264
  1. Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.



    F015025E06
  1. Using SST, push out the spider bearing from the propeller shaft.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.



    F044192E03
  1. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

    HINT:
    Remove the spider bearing on opposite side in the same procedure.

    NOTICE:
    Do not tap the shaft.



    F015030E05
  1. Install the 2 removed spider bearing outer races to the spider.

  1. Using SST, push out the bearing from the yoke.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.



    F044193E04
  1. Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

  1. Remove the spider.