Home › DRIVE LINE ยท PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 2WD)

PROPELLER SHAFT ASSEMBLY (for 2WD) > REASSEMBLY

for Preparation Click here



1. INSTALL REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING


    C060598
  1. Apply MP grease No. 2 to a new spider and bearings.

  1. Fit the spider into the flange yoke.



    C063061E03
  1. Using SST, install the bearings on the spider.

    SST
    09332-25010  

  1. Using SST, adjust both bearings so that the snap ring grooves are at maximum and equal in width.

    SST
    09332-25010  



    G020755
  1. Install new 4 snap rings of equal thickness which will allow no axial play.

    HINT:
    Do not reuse the snap rings.
    Thickness of snap ring (Both ends thin type) 
    Parts No.
    Thickness mm (in.)
    Mark
    90520-25039
    2.28 to 2.30
    1
    90520-25040
    2.30 to 2.32
    2
    90520-25041
    2.32 to 2.34
    -
    90520-25042
    2.34 to 2.36
    Brown
    90520-25043
    2.36 to 2.38
    Blue
    90520-25044
    2.38 to 2.40
    6
    90520-25045
    2.40 to 2.42
    7
    90520-25046
    2.42 to 2.44
    8
    90520-25047
    2.44 to 2.46
    C139333
    90520-25048
    2.46 to 2.48
    10
    90520-25049
    2.48 to 2.50
    A
    90520-25050
    2.50 to 2.52
    B
    90520-25051
    2.52 to 2.54
    C
    90520-25052
    2.54 to 2.56
    D
    90520-25053
    2.56 to 2.58
    E
    90520-25054
    2.18 to 2.20
    J
    90520-25055
    2.20 to 2.22
    K
    90520-25056
    2.22 to 2.24
    F
    90520-25057
    2.24 to 2.26
    G
    90520-25058
    2.26 to 2.28
    H

    NOTICE:
    1. Must use a new retainer ring.
    2. Must use retainer rings of the same thickness as possible on both ends.

  1. Using a hammer, tap the yoke until there is no clearance between the spider bearing outer race and snap ring.

    HINT:
    Install a new spider bearing on the sleeve side in the procedure described above.



2. INSPECT REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING