Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    22    Compressor Lock Sensor Circuit

for Preparation Click here


DESCRIPTION

This sensor sends 4 pulses par engine revolution to the A/C amplifier. If the ratio of the compressor speed divided by the engine speed is smaller than a predetermined value, the A/C amplifier turns the compressor off, and the indicator flashes at about 1 sec. intervals.

DTC No.
Detection Item
Trouble Area
22
All conditions below are detected for 3 sec. or more.
(a) Engine speed: 450 rpm or more.
(b) Ratio between engine and compressor speed deviates 20 % or more in comparison with normal operation.
  1. Cooler compressor assembly
  2. Compressor drive belt
  3. Compressor lock sensor
  4. Harness or connector between compressor lock sensor and A/C amplifier
  5. A/C amplifier

WIRING DIAGRAM


I045660E01


INSPECTION PROCEDURE

1.INSPECT AIR CONDITIONING AMPLIFIER (LOCK)


    I033523E06
  1. Remove the A/C amplifier with the connectors still connected.

  1. Turn the ignition switch ON.

  1. Turn the A/C switch ON.



    I031459E10
  1. Measure the waveform between terminal LOCK (A16-19) and terminal SG (A16-6) of the A/C amplifier.

    OK:
    Waveform appears as shown in the illustration.

    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from DTC)
    B
    OK (When checking from the PROBLEM SYMPTOMS TABLE)
    C



B
REPLACE AIR CONDITIONING AMPLIFIER

C
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A


2.INSPECT COOLER COMPRESSOR ASSEMBLY


    E005280E16
  1. Disconnect the connector from the cooler compressor assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A2-1 - A2-2
    at 20°C (68°F)
    165 to 205 Ω



NG
REPLACE COOLER COMPRESSOR ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (COOLER COMPRESSOR ASSEMBLY - A/C AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the cooler compressor assembly and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER