Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    23    Pressure Switch Circuit

for Preparation Click here


DESCRIPTION

The pressure switch sends appropriate signals to the A/C amplifier when the A/C refrigerant pressure drops too low or rises too high. When the A/C amplifier receives these signals, it outputs signals via the A/C amplifier to switch OFF the compressor relay and turn OFF the magnetic clutch.

DTC No.
Detection Item
Trouble Area
23
  1. Open in pressure sensor circuit
  2. Abnormal refrigerant pressure
    below 196 kPa (2.0 kgf/cm2, 28 psi)
    over 3,140 kPa (32.0 kgf/cm2, 455 psi)
  1. Pressure switch
  2. Harness or connector between pressure switch and A/C amplifier
  3. Refrigerant pipe line
  4. A/C amplifier

WIRING DIAGRAM


I045661E01


INSPECTION PROCEDURE

1.INSPECT REFRIGERANT PRESSURE
  1. Set the manifold gauge .

  1. Read the manifold gauge pressure when these conditions are established.
    Test conditions:

    1. Temperature at the air inlet with the switch set at RECIRC is 30 to 35°C (86 to 95°F)
    2. Engine running at 1,500 rpm
    3. Blower speed control switch at "HI" position
    4. Temperature control dial at "COOL" position
    5. Air conditioning switch ON
    6. Fully open doors

    Standard:
    Pressure on high pressure side:
    1.37 to 1.57 MPa (13.9 to 16.0 kgf*cm2, 198 to 228 psi)

    HINT:
    If the refrigerant pressure is below 196 kPa (2.0 kgf*cm2, 28 psi), the refrigerant amount in the air conditioning cycle may have decreased significantly for reasons such as a gas leakage.



NG
REPAIR OR REPLACE AIR CONDITIONING CYCLE
OK


2.CHECK AIR CONDITIONING OPERATION


    I040669
  1. Disconnect the pressure switch connector.

  1. Connect terminals 1 and 4 of the connector of the pressure switch on the vehicle wire harness side using a service wire.

  1. Start the engine.

  1. Turn the air conditioning switch on and check that the magnetic clutch is turned on.

  1. Check that the magnetic clutch is turned off when disconnecting terminals 1 and 4 (that are connected in the prior step).

    OK:
    Terminals 1 and 4 connected:
    the compressor is operated
    Terminals 1 and 4 disconnected:
    the compressor is not operated



NG
Go to step 3
OK

REPLACE PRESSURE SWITCH 

3.CHECK HARNESS AND CONNECTOR (PRESSURE SWITCH - AIR CONDITIONING AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the pressure switch and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK DTC
  1. Start up the DTC check mode.

  1. Check that DTC 23 is not output again.

    Result:

    Result
    Proceed to
    DTC 23 is output.
    A
    DTC 23 is not output. (Checking from the DTC)
    B
    DTC 23 is not output. (Checking from the PROBLEM SYMPTOMS TABLE)
    C



B
SYSTEM IS OK

C
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A

REPLACE AIR CONDITIONING AMPLIFIER