DTC 31 Air Mix Damper Position Sensor Circuit (Passenger Side) |

| DTC No. | Detection Item | Trouble Area |
| 31 | Open or short in air mix damper position sensor circuit |
|

| 1.INSPECT AIR CONDITIONING AMPLIFIER (TP, TPDR, SG) |
![]() |
Remove the A/C amplifier with the connectors still connected.
![]() |
Turn the ignition switch ON.
Change the set temperature to activate the air mix damper.
Measure the voltage according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| A16-25 (TP) - A16-6 (SG) | Ignition switch ON MAX. HOT position | 0.5 to 1.8 V |
| A16-25 (TP) - A16-6 (SG) | Ignition switch ON MAX. COLD position | 3.5 to 5.5 V |
| Tester Connection (Symbols) | Condition | Specified Condition |
| A16-23 (TPPA) - A16-6 (SG) | Ignition switch ON MAX. HOT position | 0.5 to 1.8 V |
| A16-23 (TPPA) - A16-6 (SG) | Ignition switch ON MAX. COLD position | 3.5 to 5.5 V |
|
| ||||
| NG | |
| 2.INSPECT DAMPER SERVO SUB-ASSEMBLY |
Remove the damper servo sub-assembly.
![]() |
Disconnect the connector from the damper servo sub-assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Always | 4.2 to 7.8 kΩ |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 2 | MAX. COLD position | 3.4 to 6.2 kΩ |
| 3 - 2 | MAX. HOT position | 0.8 to 1.6 kΩ |
![]() |
As the damper servo sub-assembly moves from COLD side to HOT side, the resistance decreases gradually without interruption.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR MIX DAMPER POSITION SENSOR - A/C AMPLIFIER) |
Check for open and short in the harness and the connector between the damper servo sub-assembly (air mix damper position sensor) and the A/C amplifier (Click here).
|
| ||||
| OK | |
| 4.CHECK DTC |
Start up the DTC check mode.
Check that DTC 31 is not output again.
| Result | Proceed to |
| DTC 31 is output. | A |
| DTC 31 is not output. | B |
|
| ||||
| A | ||
| ||