Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    33    Air Outlet Damper Position Sensor Circuit

for Preparation Click here


DESCRIPTION

This sensor detects the position of the air outlet damper and sends appropriate signals to the A/C amplifier. The position sensor is built into the mode damper servo sub-assembly (air outlet servo motor).
E109300E01

DTC No.
Detection Item
Trouble Area
33
Open or short in air outlet damper position sensor circuit
  1. Mode damper servo sub-assembly (Air outlet damper position sensor)
  2. Harness or connector between mode damper servo sub-assembly (air outlet damper position sensor) and A/C amplifier
  3. A/C amplifier

WIRING DIAGRAM


I033597E02


INSPECTION PROCEDURE

1.INSPECT AIR CONDITIONING AMPLIFIER (TPO, SG)


    I033523E11
  1. Remove the A/C amplifier with the connectors still connected.

  1. Turn the ignition switch ON.

  1. Change the set air flow mode to activate the mode damper servo sub-assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    A16-17 (TPO) - A16-6 (SG)
    Ignition switch ON
    FACE position
    3.5 to 4.5 V
    A16-17 (TPO) - A16-6 (SG)
    Ignition switch ON
    DEF position
    0.5 to 1.5 V

    HINT:
    As the mode damper is moved from FACE side to DEF side, the voltage decreases gradually without interruption.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT MODE DAMPER SERVO SUB-ASSEMBLY
  1. Remove the mode damper servo sub-assembly.



    I030157
  1. Disconnect the connector from the mode damper servo sub-assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    4.2 to 7.8 kΩ



    I034386E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 2
    FACE position
    0.8 to 1.6 kΩ
    3 - 2
    DEF position
    3.4 to 6.2 kΩ



    I030161E15
  1. As the mode damper servo sub-assembly moves from DEF side to FACE side, the resistance decreases gradually without interruption.

    HINT:
    For details regarding operation of the servo motor .



NG
REPLACE MODE DAMPER SERVO SUB-ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (AIR OUTLET DAMPER POSITION SENSOR - A/C AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the mode damper servo sub-assembly (air outlet damper position sensor) and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK DTC
  1. Start up the DTC check mode.

  1. Check that DTC 33 is not output again.

    Result:

    Result
    Proceed to
    DTC 33 is output.
    A
    DTC 33 is not output.
    B



B
SYSTEM IS OK
A

REPLACE AIR CONDITIONING AMPLIFIER