Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    41    Air Mix Damper Control Servo Motor Circuit (Passenger Side)

for Preparation Click here


DESCRIPTION

This damper servo sub-assembly (air mix damper control servo motor) is controlled by the A/C amplifier and moves the air mix damper to the desired position.

DTC No.
Detection Item
Trouble Area
41
Air mix damper position sensor value does not change even if A/C amplifier operates air mix servo motor.
  1. Damper servo sub-assembly (Air mix damper control servo motor)
  2. Harness or connector between A/C amplifier and damper servo sub-assembly (air mix damper control servo motor)
  3. A/C amplifier

WIRING DIAGRAM


I033600E01


INSPECTION PROCEDURE

1.PERFORM ACTUATOR CHECK
  1. Operate the A/C control panel to enter the actuator check mode (Click here).

  1. Press the DEF switch to enter the step operation.

  1. Check the air flow temperature by hand.

    Display Code
    Air Mix Damper Operation
    0
    COLD side (0 % open)
    1
    COLD side (0 % open)
    2
    COLD side (0 % open)
    3
    COLD/HOT (50 % open)
    4
    COLD/HOT (50 % open)
    5
    COLD/HOT (50 % open)
    6
    HOT side (100 % open)
    7
    HOT side (100 % open)
    8
    HOT side (100 % open)
    9
    HOT side (100 % open)



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT DAMPER SERVO SUB-ASSEMBLY


    I030157
  1. Remove the damper servo sub-assembly.



    I033526E02
  1. Connect the battery positive (+) lead to terminal 4 and the battery negative (-) lead to terminal 5, then check that the lever turns to "COLD" side smoothly.

  1. Connect the battery positive (+) lead to terminal 5 and the battery negative (-) lead to terminal 4, then check that the lever turns to "HOT" side smoothly.

    OK:
    Motor operates smoothly.



NG
REPLACE DAMPER SERVO SUB-ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (DAMPER SERVO SUB-ASSEMBLY - A/C AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the damper servo sub-assembly (air mix damper control servo motor) and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK DTC
  1. Start up the DTC check mode.

  1. Check that DTC 41 is not output again.

    Result:

    Result
    Proceed to
    DTC 41 is output.
    A
    DTC 41 is not output.
    B



B
SYSTEM IS OK
A

REPLACE AIR CONDITIONING AMPLIFIER