Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    43    Air Outlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

This circuit turns the servo motor and changes each mode damper position by the signals from the A/C amplifier. When the AUTO switch is on, the A/C amplifier changes the mode automatically between (FACE), (BI-LEVEL) and (FOOT) according to the temperature setting.

DTC No.
Detection Item
Trouble Area
43
Air outlet damper position sensor value does not change even if A/C amplifier operates air outlet damper control servo motor.
  1. Mode damper servo sub-assembly (Air outlet damper control servo motor)
  2. Harness or connector between A/C amplifier and mode damper servo sub-assembly (air outlet damper control servo motor)
  3. A/C amplifier

WIRING DIAGRAM


I033599E02


INSPECTION PROCEDURE

1.PERFORM ACTUATOR CHECK
  1. Warm up the engine.

  1. Operate the A/C control panel to enter the actuator check mode (Click here).

  1. Press the DEF switch to enter the step operation.

  1. Press the DEF switch, and check the air flow by hand.

    Display Code
    Air Mix Damper Operation
    0
    FACE
    1
    FACE
    2
    B/L
    3
    B/L
    4
    FOOT
    5
    FOOT
    6
    FOOT
    7
    FOOT
    8
    FOOT/DEF
    9
    DEF



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT MODE DAMPER SERVO SUB-ASSEMBLY


    I030157
  1. Remove the mode damper servo sub-assembly.



    I034386E01
  1. Connect the battery positive (+) lead to terminal 4 and the battery negative (-) lead to terminal 5, then check that the lever turns to "DEF" position smoothly.

  1. Connect the battery positive (+) lead to terminal 5 and the battery negative (-) lead to terminal 4, then check that the lever turns to "FACE" position smoothly.

    OK:
    Motor operates smoothly.



NG
REPLACE MODE DAMPER SERVO SUB-ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (MODE DAMPER SERVO SUB-ASSEMBLY - A/C AMPLIFIER)
  1. Check for open and short circuit in the harness and the connector between the mode damper servo sub-assembly (air outlet damper control servo motor) and the A/C amplifier (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK DTC
  1. Start up the DTC check mode.

  1. Check that DTC 43 is not output again.

    Result:

    Result
    Proceed to
    DTC 43 is output.
    A
    DTC 43 is not output.
    B



B
SYSTEM IS OK
A

REPLACE AIR CONDITIONING AMPLIFIER