DTC 46 Air Mix Damper Control Servo Motor Circuit (Driver Side) |
| DTC No. | Detection Item | Trouble Area |
| 46 | Air mix damper position sensor value does not change even if A/C amplifier operates air mix control servomotor servo motor. |
|

| 1.PERFORM ACTUATOR CHECK |
Operate the A/C control panel to enter the actuator check mode (Click here).
Press the DEF switch to enter the step operation.
Check the air flow temperature by hand.
| Display Code | Air Mix Damper Operation |
| 0 | COLD side (0 % open) |
| 1 | COLD side (0 % open) |
| 2 | COLD side (0 % open) |
| 3 | COLD/HOT (50 % open) |
| 4 | COLD/HOT (50 % open) |
| 5 | COLD/HOT (50 % open) |
| 6 | COLD/HOT (50 % open) |
| 7 | HOT side (100 % open) |
| 8 | HOT side (100 % open) |
| 9 | HOT side (100 % open) |
|
| ||||
| NG | |
| 2.INSPECT DAMPER SERVO SUB-ASSEMBLY |
![]() |
Remove the damper servo sub-assembly.
![]() |
Connect the battery positive (+) lead to terminal 4 and the battery negative (-) lead to terminal 5, then check that the lever turns to "COLD" side smoothly.
Connect the battery positive (+) lead to terminal 5 and the battery negative (-) lead to terminal 4, then check that the lever turns to "HOT" side smoothly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (DAMPER SERVO SUB-ASSEMBLY - A/C AMPLIFIER) |
Check for open and short in the harness and the connector between the damper servo sub-assembly (air mix damper control servo motor) and the A/C amplifier (Click here).
|
| ||||
| OK | |
| 4.CHECK DTC |
Start up the DTC check mode.
Check that DTC 46 is not output again.
| Result | Proceed to |
| DTC 46 is output. | A |
| DTC 46 is not output. | B |
|
| ||||
| A | ||
| ||