Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > REMOVAL

for Preparation Click here



1. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B062740E01
  1. Disengage the 5 clips and 2 claws, and remove the console upper rear panel, and then disconnect the connectors.



2. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER


    B062741E01
  1. Disengage the 6 clips and 2 claws, and then remove the upper console panel sub-assembly.

    NOTICE:
    Be careful not to snap the claws during the operation.



3. REMOVE CONSOLE UPPER PANEL GARNISH NO. 1


    B062742E01
  1. Disengage the clip.

  1. Pull the No. 1 console upper panel garnish rearward to be removed.



4. REMOVE CONSOLE UPPER PANEL GARNISH NO. 2


5. REMOVE CONSOLE BOX ASSEMBLY REAR


    B078371E01
  1. Disconnect the connectors.

  1. Remove the 6 bolts <B> and rear console box assembly.



6. REMOVE COWL SIDE TRIM BOARD RH


    B062748E01
  1. Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board RH.



7. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2


    B062749E01
  1. Remove the screw <E>.

  1. Disengage the 3 clips and remove the No. 2 instrument panel under cover sub-assembly.



8. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY


9. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY


    B062750E01
  1. Remove the screw <F> and glove compartment door.

  1. Deform the upper part of the glove compartment door to release the stoppers.

  1. Pull the glove compartment door upward to remove it.



10. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER NO. 2


    B062751E01
  1. Remove the 4 screws <E>.

  1. Disengage the 2 claws and remove the instrument panel finish panel.



11. REMOVE INSTRUMENT PANEL REGISTER ASSEMBLY NO. 2


    B062752E01
  1. Remove the screw <G>.

  1. Disengage the 2 clips and 2 claws, and then remove the No. 2 instrument panel register assembly.



12. REMOVE AIR DUCT NO. 2


    I034330E01
  1. Remove the 4 bolts and disconnect the Instrument panel safety pad sub-assembly.

  1. Remove the 3 claw fittings and remove the air duct No. 2.



13. REMOVE BLOWER ASSEMBLY


    I034331E01
  1. Release the 7 clamps and disconnect the connectors.



    I034332E02
  1. Remove the bolt and 2 screws and nut.

  1. Release the claw fitting and remove the blower assembly.