Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)



2. REMOVE FAN AND GENERATOR V BELT


3. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    I033926
  1. Remove the nut and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the discharge hose sub-assembly.

    NOTICE:
    Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    I033927
  1. Remove the nut and disconnect the cooler refrigerant suction hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the cooler refrigerant suction hose sub-assembly.

    NOTICE:
    Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



5. REMOVE COMPRESSOR AND MAGNETIC CLUTCH


    I033928
  1. Disconnect the connector.

  1. Remove the nut.

  1. Remove the 3 bolts, stay, compressor and magnetic clutch.