Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE) > REASSEMBLY

for Preparation Click here



1. INSTALL MAGNETIC CLUTCH ASSEMBLY


    I032460
  1. Fit the parts shown in the illustration and install the magnetic clutch starter.



    I032461
  1. Using a snap ring expander, install a new snap ring with the chamfered side facing up.

  1. Install the screw and connect the connector.



    I031582
  1. Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing up.

  1. Install the magnetic clutch washer and magnetic clutch hub.

    NOTICE:
    Do not change the combination of the magnetic clutch washers used before disassembly.



    I033498
  1. Using SST, install the magnetic clutch hub and magnetic clutch washer with the bolt.

    SST
    09960-10010   (09962-01000, 09963-00500)

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }