Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 1GR-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 1GR-FE) > REMOVAL

for Preparation Click here



1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)



2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1


3. REMOVE FAN AND GENERATOR V BELT


4. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    I034404
  1. Remove the nut and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the discharge hose sub-assembly.

    NOTICE:
    Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matters from entering.



5. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    I034405
  1. Remove the nut and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the opening of the disconnected parts using vinyl tape to prevent moisture and foreign matters from entering.



6. REMOVE COMPRESSOR AND MAGNETIC CLUTCH


    I034406
  1. Disconnect the connector.

  1. Remove the 4 bolts and the compressor and magnetic clutch.