Home › ENGINE ยท 2UZ-FE › EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS


    A074799
  1. Check for cracks, leaks or damage.

    HINT:
    Separation of the engine oil dipstick, oil filler cap, PCV hose, etc. may cause an engine failure or engine malfunctions. Disconnection, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will allow air suction and cause an engine failure or engine malfunctions.



2. CHECK AIR TIGHTNESS IN FUEL TANK AND FILLER PIPE


    A067134E02
  1. Disconnect the vent line hose from the fuel tank .

  1. Apply pressure to the fuel tank and make the internal pressure of the air pressure 4 kPa (41 gf/cm2, 0.58 psi).

  1. Check that the internal pressure of the fuel tank is maintained for 1 minute.

  1. Check the connections for each hose and pipe.

  1. Check the installed parts on the fuel tank. If there is no abnormality, replace the fuel tank and filler pipe.

  1. Reconnect the vent line hose to the fuel tank.



3. INSPECT FUEL CUT-OFF VALVE AND FILL CHECK VALVE


    A067135E02
  1. Disconnect the vent line hose from the fuel tank .

  1. Apply 4 kPa (41 gf/cm2, 0.58 psi) to the vent port of the fuel tank.

    HINT:
    In the condition that the fuel is full, as the float value of the fill check valve is closed and has no ventilation, it is necessary to check the fuel amount (volume).

  1. Remove the fuel tank cap, and check that the pressure inside the tank drops.
    If pressure does not drop, replace the fuel tank assembly.

  1. Reconnect the vent line hose to the fuel tank.



4. CHECK AIR INLET LINE


    A067136E03
  1. Disconnect the air inlet line hose from the charcoal canister.

  1. Check that there is ventilation in the air inlet line.

  1. Reconnect the air inlet line hose to the charcoal canister.