Home › ENGINE ยท 2UZ-FE › EMISSION CONTROL › AIR SWITCHING VALVE

AIR SWITCHING VALVE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 2 AIR SWITCHING VALVE


    A133802
  1. Disconnect the vacuum hose from the VSV for the air injection system (Procedure "A").

  1. Apply vacuum (30 kPa (306 gf/cm2, 4.35 psi)) to the vacuum hose, and check that the vacuum does not decrease (Procedure "B").
    If operation is not as specified, replace the No. 2 air switching valve.



    A133803
  1. Release the vacuum, and check that an operation sound is emitted from the No. 2 air switching valve (Procedure "C").
    If operation is not as specified, replace the No. 2 air switching valve.

  1. Perform procedures "A" to "C" for the other No. 2 air switching valve.