Home › DRIVE LINE ยท PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 4WD)

PROPELLER SHAFT ASSEMBLY (for 4WD) > DISASSEMBLY

for Preparation Click here



1. REMOVE RR PROPELLER SHAFT UNIVERSAL JOINT SLEEVE YOKE SUB-ASSEMBLY


    G022296E01
  1. Place matchmarks on the propeller shaft and sleeve yoke.

  1. Remove the sleeve yoke from the propeller shaft.

  1. Remove the grease fitting from the universal joint sleeve yoke.



2. REMOVE REAR PROPELLER SHAFT SLIDING SHAFT DUST COVER SUB-ASSEMBLY


    D003048E02
  1. Cut the dust cover spirally at the pressing-in part with a saw and pry it off with a chisel.

    NOTICE:
    Do not damage the propeller shaft. If damage, replace the shaft with a new one.



3. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING


    F015023E08
  1. Place matchmarks on the flange yoke and sleeve yoke.



    C061264
  1. Using a brass bar and a hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.



    F015025E07
  1. Using SST, push out the spider bearing from the propeller shaft.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the spider bearing.



    F044192E04
  1. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.

    HINT:
    Remove the spider bearing on opposite side in the same procedure.

    NOTICE:
    Do not tap the shaft.



    F015030E06
  1. Install the 2 removed spider bearing outer races to the spider.

  1. Using SST, push out the bearing from the yoke.

    SST
    09332-25010  

    HINT:
    Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.



    F044193E05
  1. Clamp the outer bearing race in a vise and tap off the yoke with a hammer.

  1. Remove the spider.