Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat)

REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat) > INSTALLATION

for Preparation Click here


HINT:
Use the same procedures for the LH and RH.



1. INSTALL 3 POINT TYPE BELT ASSEMBLY RH (for Rear No. 2 Seat)
  1. Check the degree of tilt when the belt begins to lock the ELR.

    NOTICE:
    Do not disassemble the retractor.

  1. Check the amount of inclination required to lock the retractor.

    1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
      If operation is not as specified, replace the belt assembly.

  1. Install the rear No. 2 seat belt inner with the bolt and nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the belt on the retractor side with the 2 bolts.

    Torque:
    for upper bolt:
    8.5 N*m{ 87 kgf*cm , 75 ft.*lbf }
    for lower bolt:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the roof side garnish inner RH.

  1. Install the belt outer on the shoulder anchor side with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the deck trim side panel RH.

  1. Install the belt outer on the floor anchor side with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

  1. Install the floor anchor cover.

  1. Check the ELR lock.

    NOTICE:
    The check should be performed with the outer belt assembly installed.


    1. With the belt installed, check that the belt locks when it is pulled out quickly.
      If operation is not as specified, replace the belt assembly.

  1. Check the fastening function of the child restraint system.

    NOTICE:
    The check should be performed with the outer belt installed.


    1. When the belt is pulled out fully, the belt should automatically try to retract.

    2. After the belt has fully retracted, the belt should be able to be pulled out and retract again.
      If operation is not as specified, replace the belt assembly.



2. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER RH


3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH


4. INSTALL REAR FLOOR CARPET ASSEMBLY


5. INSTALL REAR DOOR WEATHERSTRIP RH


6. INSTALL REAR DOOR SCUFF PLATE RH


7. INSTALL QUARTER SCUFF PLATE INNER RH


8. INSTALL SIDE TRIM BOX ASSEMBLY RH


9. INSTALL DECK TRIM SIDE BOARD UPR RH


10. INSTALL DECK TRIM COVER REAR


11. INSTALL DECK FLOOR BOX RH


12. INSTALL REAR FLOOR MAT SUPPORT PLATE REAR


13. INSTALL BACK DOOR GLASS WEATHERSTRIP


14. INSTALL REAR NO. 2 SEAT LOCK ASSEMBLY


15. INSTALL NO.2 SEAT LEG COVER


16. INSTALL REAR NO. 2 SEAT ASSEMBLY RH


17. INSTALL REAR NO. 2 SEAT ASSEMBLY LH


18. INSTALL TONNEAU COVER RETRACTOR SUB-ASSEMBLY