Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat)

REAR SEAT OUTER BELT ASSEMBLY (for Rear No. 2 Seat) > REMOVAL

for Preparation Click here


HINT:
Use the same procedures for the LH and RH.



1. REMOVE TONNEAU COVER RETRACTOR SUB-ASSEMBLY


2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


3. REMOVE REAR NO. 2 SEAT ASSEMBLY RH


4. REMOVE NO.2 SEAT LEG COVER


5. REMOVE REAR NO. 2 SEAT LOCK ASSEMBLY RH
  1. Remove the 2 bolts and seat lock.



6. REMOVE BACK DOOR GLASS WEATHERSTRIP


7. REMOVE REAR FLOOR MAT SUPPORT PLATE REAR


8. REMOVE DECK FLOOR BOX RH
  1. Remove the 2 bolts and seat lock.



9. REMOVE DECK TRIM COVER REAR
  1. Using a screwdriver, pry out the trim cover.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE DECK TRIM SIDE BOARD UPR RH
  1. Remove the screw and side board.



11. REMOVE SIDE TRIM BOX ASSEMBLY RH
  1. Remove the screw and side trim box.



12. REMOVE QUARTER SCUFF PLATE INNER RH


13. REMOVE REAR DOOR SCUFF PLATE RH


14. REMOVE REAR DOOR WEATHERSTRIP RH


15. REMOVE REAR FLOOR CARPET ASSEMBLY


16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Remove the floor anchor cover.

  1. Remove the bolt and seat belt outer on the floor anchor side.

  1. Remove the shoulder anchor cover.

  1. Remove the bolt and seat belt outer on the shoulder anchor side.

  1. Remove the trim side panel.



17. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER RH


18. REMOVE 3 POINT TYPE BELT ASSEMBLY RH (for Rear No. 2 Seat)
  1. Remove the 2 bolts on the retractor side, and thoroughly remove the seat belt.