Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
SKID CONTROL ECU COMMUNICATION STOP MODE
  1. "ABS/VSC/TRAC" is not displayed on the "BUS CHECK" screen of the intelligent tester via the CAN VIM.
  2. DTCs are output from each ECU in skid control ECU communication stop mode as shown in the "DTC COMBINATION TABLE" (Click here).
  1. Power source or inside the skid control ECU
  2. Skid control ECU sub bus line or connector

WIRING DIAGRAM


G036690E01


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (SKID CONTROL ECU SUB BUS LINE)


    E069126E55
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the skid control ECU connector (S28).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified value
    S28-11 (CANH) - S28-25 (CANL)
    1. IG switch OFF
    2. Stop light switch OFF
    54 to 69 Ω



NG
REPAIR OR REPLACE SKID CONTROL ECU SUB BUS LINE OR CONNECTOR (CAN-H, CAN-L)
OK


2.CHECK WIRE HARNESS (IG, GND2)


    E069126E56
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified value
    S28-32 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified value
    S28-46 (IG1) - Body ground
    IG switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID