Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE FUNCTION
  1. When communication fails in any of the CAN bus lines (communication lines) due to a short circuit or any other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning.

  2. This function operates for each system when communication is impossible. (For further details, see the pages for each system.)

    Function
    ECM
    Skid Control ECU
    Steering Angle Sensor
    Yaw Rate Sensor
    Action when unable to communicate
    DTC detection
    (Driver detectable)
    VSC Control
    (Controls VSC/TRC engine output)
    -
    Rx
    Tx
    Tx
    VSC function stops
    Detectable
    (Light comes on)
    VSC Control
    (Controls VSC/TRC engine output)
    Rx or Tx
    Tx or Rx
    -
    -
    VSC function stops
    Detectable
    (Light comes on)

    HINT:
    1. Rx: Reception from each ECU (sensor).
    2. Tx: Transmission to each ECU (sensor).