THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (SECURITY INDICATOR LIGHT) |
![]() |
Disconnect the A/C control connector.
Connect 3 dry batteries of 1.5 V in series.
Apply 4.5 V positive voltage between each terminal of the A/C control, and check the lighting condition of the security indicator light.
| Symbols (Terminal No.) | Specified Condition |
| SIND (D3-12) - GND (D3-7) | Lights up |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY INDICATOR LIGHT) |
![]() |
Disconnect the T5 ECU and D3 A/C control connectors.
Check the continuity between the wire harness side connectors.
| Symbols (Terminal No.) | Specified Condition |
| IND (T5-25) - SIND (D3-12) | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND) |
![]() |
Disconnect the D3 A/C control connector.
Check the continuity between the wire harness side connectors.
| Symbols (Terminal No.) | Specified Condition |
| SIND (D3-12) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||