Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


  1. Inspect the buckle switch.



      B060004E01
    1. Fasten the seat belt (Buckle switch is ON).

    2. Inspect the continuity and resistance between the terminals.

      Standard resistance:
      Terminal No.
      Specified Condition
      A-6 - A-3
      1,330 Ω
      A-4 - A-3
      Continuity
      A-5 - A-3
      * Continuity

      NOTICE:
      * When the positive and negative poles between terminals are exchanged, there is continuity in one way but no continuity in the other way.



    3. B060004E02
    4. Release the seat belt (Buckle switch is OFF).

    5. Inspect the continuity and resistance between the terminals.

      Standard resistance:
      Terminal No.
      Specified Condition
      A-6 - A-3
      330 Ω
      A-4 - A-3
      No Continuity
      A-5 - A-3
      * No Continuity

      NOTICE:
      * When the positive and negative poles between terminals are exchanged, there is no continuity in either way.

      If the result is not as specified, replace the inner belt assembly.



    B065625E01
  1. Inspect the circuit for the airbag seat position sensor.

    1. Inspect the continuity between connector A and the connector for the airbag seat position sensor.

      Standard resistance:
      Terminal No.
      Specified Condition
      A-2 - 1
      (Connector for airbag seat position sensor)
      Continuity
      A-1 - 2
      (Connector for airbag seat position sensor)

      If the result is not as specified, replace the inner belt assembly.



2. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH


  1. Inspect the buckle switch.



      B059310E01
    1. Fasten the seat belt (Buckle switch is ON).

    2. Inspect the continuity and resistance between the terminals.

      Standard resistance:
      Terminal No.
      Specified Condition
      A-2 - A-4
      1,330 Ω
      A-1 - A-3
      Continuity



    3. B059310E03
    4. Release the seat belt (Buckle switch is OFF).

    5. Inspect the continuity and resistance between the terminals.

      Standard resistance:
      Terminal No.
      Specified Condition
      A-1 - A-3
      330 Ω
      A-2 - A-4
      No Continuity

      If the result is not as specified, replace the inner belt assembly.