Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT PROTECTOR RETAINER

HEADLIGHT PROTECTOR RETAINER > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT PROTECTOR RETAINER UPPER LH

HINT:
When only the installation part of the headlight unit assembly LH is damaged, it can be repaired inexpensively by using a headlight protector retainer upper LH. In this case, however, the headlight unit assembly LH itself should not be damaged.



    I034335
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the headlight protector retainer upper LH against the bosses and gradually file away the old bracket if it interferes with the installation of the supply bracket.



    I034336
  1. Install the headlight protector retainer upper LH with the 2 screws.



2. INSPECT HEADLIGHT AIMING
  1. Cover the headlight or disconnect the connector of the headlight on the opposite side to prevent light from the headlight that is not being inspected from affecting headlight aiming inspection.

    NOTICE:
    Do not keep the headlight covered for more than 3 minutes. The headlight lens is made of synthetic resin, and may easily melt or be damaged due to heat.

    HINT:
    When checking the aim of the high-beam, cover the low-beam or disconnect the connector.

  1. Start the engine.

    NOTICE:
    Engine rpm must be 1,500 or more.



  1. Turn on the headlight and make sure that the cutoff line falls within the specified area as shown in the illustration.


    I041213E07



3. ADJUST HEADLIGHT AIMING


    E116126E01
  1. Adjust the aim vertically:
    Adjust the headlight aim into the specified range by turning the aiming screw with a screwdriver.

    NOTICE:
    The final turn of the aiming screw should be made in the clockwise direction. If the screw is tightened excessively, loosen it and then retighten it, so that the final turn of the screw is in the clockwise direction.

    HINT:
    1. Perform low-beam aim adjustment.
    2. The headlight aim moves down when turning the aiming screw clockwise, and moves up when turning the aiming screw counterclockwise.