Home › BODY ELECTRICAL › LIGHTING › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR TRIM BOARD


    B062858E01
  1. Remove the assist strap hole cover.

  1. Remove the screw and assist strap.

  1. Using a screwdriver, remove the back door trim cover.

    HINT:
    Tape the screwdriver tip before use.
    In order to prevent the back door from being damaged, cover the parts indicated by arrow marks in the illustration with tape.

  1. Using a clip remover, remove the 10 clips and trim board.

  1. Remove the inner weatherstrip.



2. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE


3. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    I033435
  1. Loosen the 4 screws and remove the licence plate light assembly.



4. REMOVE LICENSE PLATE LIGHT LENS


    I033436
  1. Remove the 4 screws and 2 license plate light lenses.



5. REMOVE LICENSE PLATE LIGHT LENS GASKET


6. REMOVE LICENSE PLATE LIGHT BULB


    I033437
  1. Remove the 2 license plate light bulbs as shown in the illustration.



7. REMOVE LICENSE PLATE LIGHT BODY