Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MULTIPLEX NETWORK DOOR ECU BACK (BACK DOOR ECU)

B062706E04

  1. Disconnect the B8 and B9 ECU connectors, and check the voltage or continuity of each terminal of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring Color
    Condition
    Specified Condition
    BDR (B8-4) - Body Ground
    L - -
    Constant
    10 to 14 V
    BECU (B8-5) - Body Ground
    L-R - -
    Constant
    10 to 14 V
    GND (B8-3) - Body Ground
    W-B - -
    Constant
    Continuity
    SIG (B8-6) - Body Ground
    B - -
    No key inserted in ignition key cylinder → Key inserted
    No continuity → Continuity
    HSW+ (B9-10) - Body Ground
    V-W - -
    Back door opener switch OFF → ON
    No continuity → Continuity
    HSW- (B9-22) - Body Ground
    LG-R - -
    HALF (B9-6) - Body Ground
    R-G - -
    Back door OPEN → CLOSED
    Continuity → No continuity
    LSE (B9-21) - Body Ground
    B-R - -
    Constant
    Continuity
    If the result is not as specified, there may be a malfunction on the wire harness side.

  2. Reconnect the connectors, and check the voltage of each terminal of the connectors.

    Symbols (Terminal No.)
    Wiring Color
    Condition
    Specified Condition
    ACT+ (B9-15) - Body Ground
    L-B - -
    Back door OPEN → NOT COMPLETELY CLOSED → Motor in normal rotation (Right turn) → Motor in revers rotation (Left turn) → Operation completed (Back door CLOSED)
    Below 1 V → Below 1 V → 10 to14 V → Below 1 V → Below 1 V
    ACT- (B9-14) - Body Ground
    L-R - -
    Back door OPEN → NOT COMPLETELY CLOSED → Motor in normal rotation (Right turn) → Motor in revers rotation (Left turn) → Operation completed (Back door CLOSED)
    Below 1 V → Below 1 V → Below 1 V → 10 to 14 V → Below 1 V
    FULL (B9-7) - Body Ground
    G-Y - -
    Back door CLOSED → OPEN
    10 to 14 V → Below 1 V
    POS (B9-8) - Body Ground
    BR-W - -
    Back door OPEN → Closer in operation → CLOSED
    Below 1 V → 10 to 14 V → Below 1 V
    If the result is not as specified, the vehicle may be defective. In this case, check the harness, connector and fuse between the ECU and battery. Then repair or replace it if necessary.