HOOD > ADJUSTMENT |
| 1. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance is within the standard value.

| Area | Measurement |
| A | 3.9 +- 1.5 mm (0.154 +- 0.059 in.) |
| B | 0.4 +- 1.5 mm (0.015 +- 0.059 in.) |
| 2. ADJUST HOOD SUB-ASSEMBLY |
![]() |
Horizontally adjust the hood.
![]() |
Loosen the hood side hinge bolts.
![]() |
Adjust the clearance so that it will be in the standard value, by moving the hood.
Tighten the hood side hinge bolts after the adjustment.
![]() |
Adjust the height of the hood front end by the cushion rubber.
Adjust the cushion rubber so that the hood and the fender will be aligned.
![]() |
Adjust the hood lock.
Using a clip remover, disengage the clips, remove the 8 radiator support seal upper clips.
Remove the radiator support seal upper.
![]() |
Using a screwdriver, disengage the 4 clips.
Remove the hood lock release lever protector.
![]() |
Adjust the hood lock position so that the striker will come in, by moving the striker.
Tighten the hood lock bolts after the adjustment.