FRONT DOOR > ADJUSTMENT |
| 1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH |
Check that the clearance is within the standard value.

| Area | Measurement |
| A | 4.5 +- 1.5 mm (0.177 +- 0.059 in.) |
| B | 5.6 +- 1.5 mm (0.220 +- 0.059 in.) |
| C | 7.6 +- 1.5 mm (0.299 +- 0.059 in.) |
| D | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) |
| E | 160 mm (6.30 in.) |
| 2. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH |
![]() |
Adjust the front door panel position.
![]() |
Put protective tape on the door panel and fender, as shown in the illustration.
![]() |
Open the door, and remove the 5 clips.
Remove the gap between the front fender side panel protector LH from the gap between the fender and door.
![]() |
Using SST, horizontally and vertically adjust the door by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Adjust the door by loosening the door side hinge bolts forward/ rearward and vertically.
Tighten the door side hinge bolts after the adjustment.
Install the front fender side panel protector LH with the 5 clips.
![]() |
Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Tighten the striker mounting screws after the adjustment.
Connect the negative (-) terminal cable from the battery.
Initialize both systems.
Check the SRS warning lamp.