FRONT DOOR > REASSEMBLY |
| 1. INSTALL FRONT DOOR WIRE LH |
![]() |
Install the door wire with the 2 bolts.
Connect the door wire clips.
| 2. INSTALL FRONT DOOR CHECK ASSEMBLY LH |
![]() |
Apply MP grease to the sliding parts of the door check.
Install the door check to the door panel with the 2 nuts.
Apply adhesive to the bolt.
Install the door check to the body panel with the bolt.
| 3. INSTALL FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH |
![]() |
Using a "torx" socket wrench (T30), install the outside handle frame with the screw.
Install the outside handle pad front and rear.
| 4. INSTALL FRONT DOOR W/MOTOR LOCK ASSEMBLY LH |
Apply MP grease to the sliding and rotating parts of the door lock.
Install a new door lock wire harness packing.
Insert the outside handle link into the lock with the door motor, and then set it to the door panel.
![]() |
Apply adhesive to the 3 screws.
Using a "torx" socket wrench (T30), install the door lock with the 3 screws.
Connect the door lock connector.
| 5. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH |
![]() |
Using a "torx" socket wrench (T30), install the outside handle cover with the screw.
Install the hole plug.
| 6. INSTALL FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER LH |
![]() |
Install the door frame with the bolt.
| 7. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
Align the matchmarks on the regulator motor gear and regulator gear.
Using a "torx" driver (T25), install the door regulator motor with the 3 screws.
| 8. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH |
![]() |
Apply MP grease to the sliding and rotating parts of the window regulator.
![]() |
Install the window regulator with the 6 bolts.
Connect the window regulator connector.
| 9. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH |
![]() |
Install the glass run.
Insert the door glass into the door panel along the glass run, as shown in the illustration.
![]() |
Install the door glass to the window regulator with the 2 bolts.
Inspect operation of the power window.
Connect the power window switch to the wire harness and turn the ignition switch ON.
Repeat UP and DOWN operation several times in the manual operation.
| 10. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Install the No. 1 speaker bracket with the 2 bolts.
Connect the speaker connector.
Install the No. 2 speaker with the 2 bolts.
| 11. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |
![]() |
Install the outer rear view mirror with the 3 nuts.
Connect the outer rear view mirror connector.
| 12. INSTALL FRONT DOOR SERVICE HOLE COVER LH |
![]() |
Apply butyl tape to the door, as shown in the illustration.
Install the service hole cover.
| Area | Measurement |
| A | 6 mm (0.236 in.) |
| B | 2 mm (0.079 in.) |