REAR DOOR > REASSEMBLY |
| 1. INSTALL REAR DOOR CHECK ASSEMBLY LH |
![]() |
Apply MP grease to the sliding part of the door check.
Install the door check to the door panel with the 2 nuts.
Apply adhesive to the bolt.
Install the door check to the body panel with the bolt.
| 2. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH |
![]() |
Using a "torx" socket wrench (T30), install the handle frame with the screw.
| 3. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH |
![]() |
Install the outside handle pad front and rear.
Pull and hold the release plate of the outside handle frame, as shown in the illustration.
![]() |
Pushing the outside handle in the arrow mark direction as shown in the illustration, install the outside handle.
| 4. INSTALL REAR DOOR OUTSIDE HANDLE COVER LH |
Using a "torx" socket wrench (T30), install the outside handle cover with the screw.
| 5. INSTALL REAR DOOR WITH MOTOR LOCK ASSEMBLY LH |
Apply MP grease to the sliding and rotating parts of the door lock.
Install a new door lock wire harness packing.
Engage the lock with door motor with the release plate of the outside handle, and then set it to the door panel.
![]() |
Apply adhesive to the 3 screws.
Using a "torx" socket wrench (T30), install the door lock with the 3 screws.
Connect the door lock connector.
| 6. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
Using a "torx" driver (T25), install the door window regulator motor with the 3 screws.
| 7. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH |
![]() |
Apply MP grease to the sliding and rotating parts of the window regulator.
![]() |
Install the door window regulator with the 4 bolts.
Connect the window regulator connector.
| 8. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH |
Insert the rear door glass into the door panel.
| 9. INSTALL REAR DOOR QUARTER WINDOW GLASS LH |
Install the quarter window weatherstrip to the door glass.
![]() |
Install the door quarter window glass as shown in the illustration.
| 10. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH |
![]() |
Insert the division bar to the door panel, then rotate it by 90° as shown in the illustration.
Mount the door glass to the window regulator.
![]() |
Tighten the division bar with the 2 bolts and screw.
Install the glass run.
Connect the power window switch to the wire harness and turn the ignition switch ON.
Repeat UP and DOWN operation several times in manual operation.
| 11. INSTALL REAR DOOR SERVICE HOLE COVER LH |
![]() |
Apply butyl tape to the door, as shown in the illustration.
Install the service hole cover.
| Area | Measurement |
| A | 6 mm (0.236 in.) |
| B | 2 mm (0.079 in.) |