BACK DOOR > REASSEMBLY |
| 1. INSTALL CENTER STOP LIGHT ASSEMBLY (w/ Rear Spoiler) |
![]() |
Install the stop light assembly with the 2 bolts.
| 2. INSTALL CENTER STOP LIGHT ASSEMBLY (w/o Rear Spoiler) |
| 3. INSTALL REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler) |
![]() |
Connect the center stop light connector.
Install the spoiler with the 2 bolts and 2 grommets.
| 4. INSTALL BACK DOOR LOWER STOPPER CUSHION |
Install the lower stopper cushion with the 2 bolts.
| 5. INSTALL BACK DOOR STOPPER LOWER |
Install the stopper lower with the bolt.
| 6. INSTALL TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) |
![]() |
Install the television camera assembly and the 2 screws.
Install the connector clamp and reconnect the connector.
| 7. INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE |
| 8. INSTALL BACK DOOR LOCK CYLINDER |
Install the lock cylinder with 2 the nuts.
Install the tailgate control switch.
| 9. INSTALL REAR WIPER MOTOR ASSEMBLY |
Install the rear wiper motor assembly .
Install the liner wiper step LH.
| 10. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH REAR |
![]() |
Apply MP grease to the as shown in the illustration.
![]() |
With the holding tool installed, match the holding tool with the motor housing.
![]() |
Push down on the wire guide and drum, and insert the drum into the motor housing.
![]() |
Install the cover plate with the 2 screws.
Install the window regulator motor with the window regulator.
| 11. INSTALL BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY |
![]() |
Apply MP grease to the sliding and rotating parts of the window regulator.
![]() |
Install the power regulator sub-assembly with the 6 bolts, nut.
Connect the window regulator connector.
Install the 2 cushion rubbers.
| 12. INSTALL W/MOTOR BACK DOOR LOCK ASSEMBLY |
![]() |
Install the door lock with 4 bolts.
Connect the connector.
Install the door lock protector.
![]() |
Install the 2 regulator control wires as shown in the illustration.
| 13. INSTALL BACK DOOR GLASS |
![]() |
Insert the door glass as shown in the illustration.
![]() |
Install the door glass with the 4 bolts.
Connect the rear window defogger connector.
| 14. INSTALL BACK DOOR GLASS RUN |
![]() |
Install the door glass run.
Check that the glass run position as shown in the illustration.
| 15. INSTALL BACK DOOR SERVICE HOLE COVER |
![]() |
If replacing protector:
Install the protector, as shown in the illustration.
Install the back door service hole cover with the 5 bolts.
Install the multiplexnetwork door ECU with the 2 bolts.
Connect the multiplexnetwork door ECU connector.
| 16. INSTALL BACK DOOR SERVICE HOLE COVER LH |
![]() |
Apply butyl tape to the door.
Install the service hole cover, as shown in the illustration.